2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
2 Likes5 DownloadsApril 19, 2022
This model is restricted by licensing terms.
View license.
Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4874636.
I suck at soldering so I whipped up this terminal block thingy that anyone can add to their own models. I personally used it to construct DIY perks studio lights. I'll post my variation with the terminal blocks as well.
Materials: M3x10-ish bolt M3 square or regular hex nut 20 AWG wire (max size, I don't know how much smaller I would go)
Instructions:
- insert 20awg wire through one end of the bottom square hole running the entire length of the block and push it clear to the other side, this will be the wire connecting all of the other wires together.
- pull the wire out the other side a decent amount.
- measure the length of the terminal block and strip that much off of the end of the wire.
- pull the length of wire back through the terminal block from the opposite side.
- only pull it out enough to where you can see the stripped wire in every station.
- insert a bolt to pinch the wire in the correct place.
- strip, twist, and insert a new wire you wish to connect to a station in one of the circular holes on the face of the terminal block.
- insert an M3 nut into the rectangular hole above the circular hole
- bolt it down from the top and be careful not to tighten it so much that the wires start to excessively twist, just firm enough to ensure proper contact
2 Likes5 DownloadsApril 19, 2022
This model is restricted by licensing terms.
View license.
2 Likes5 DownloadsApril 19, 2022
This model is restricted by licensing terms.
View license.