💀 Over two months. Every vertex hand-sculpted. Zero regrets.

Going back to Cyberpunk aesthetics felt like rediscovering a part of myself, reconnecting with every piece of art, every game, every neon-drenched visual that shaped me growing up in the 90s. The CyberSkull Apex is the project I didn't know I needed to make, and it's one I'm genuinely proud of.

🔩 Fully Hand-Modeled. Built for Makers.

Every geometry was sculpted by hand, which means filling cavities directly in your slicer is clean and intuitive. No guesswork, no messy boolean leftovers.

• Support-free by design. Orientations are dialed in.
• Easy to customize and split directly in your slicer
• Prints perfectly at standard 0.2mm layer height
• For a showcase-worthy result, drop to 0.12mm and let it shine

🛠️ Assembly

Easier than it looks. Seriously.

1. Insert the rod into the jaw first
2. Align the skull with the jaw
3. From each side, insert a rotator and twist it toward the back of the skull until you feel the click

Cable Management

3 channels at different diameters accommodate any cable, from the thinnest headphone wire to a chunky braided one. Two optional loops guide the cable cleanly toward the back for a polished desktop setup. The natural flex of PLA lets you gently open them to thread a cable through. Don't force them.

Teeth

Each tooth is a separate piece that slots in and holds on its own. A drop of strong CA glue locks them permanently if needed.

Feet

Two articulated feet at the rear base anchor the stand firmly to your desk.

🖨️ Printing Details

• Nozzle: 0.4 mm
• Layer Height: 0.2 mm (0.12 mm recommended for display builds)
• Walls: 2
• Infill: Hatch 8% or Cubic 15%
• Supports: OFF, not needed!
• Min. Build Volume: 20 cm x 16 cm x 23 cm

📦 3MF Files Ready to Print Out-of-the-Box

I've fine-tuned countless custom settings: infill, speed, bridges, seams, and more. Hours of research in slicer wikis go into every file to give our Thangs supporters the best plug-and-play experience.

The included 3MF files are optimized for Bambu Studio and should work correctly with Orca Slicer and Prusa Slicer. Using them in other slicers may break alignment, colors, and custom settings.

💬 Join the Conversation

I'd love to see your prints! Share them on our Holoprops Discord and connect with the community.

📜 Licensing

All Holoprops models are 100% original creations, hand-sculpted with care and creativity. These models are my own intellectual property and are protected accordingly.

Personal use only. For commercial rights, join our Merchant Tier on Thangs.