First Look Pocket Pangolin

I wanted to provide a small status update today with a small look into a few things to expect over the next couple of weeks. It's been a very busy week for me and I unfortunately haven't been able to create as much content as I had hoped due to some events regarding one of my cats who sadly will require an operation next week but I'll be sure to do my best to design and bring you all some awesome 3D printed content.

So firstly I wanted to provide a small insight into the new pocket pangolin hopefully due next week, based on the popular pangolin but much smaller and cuter and built from the ground up.

He features the popular new link system and prints in half the time of the larger pangolin. Don't be fooled though, he's still super flexi but now he's small enough to fit on any sized print bed and in any hand. I still haven't yet decided how to release the pocket pangolin, whether he should be an exclusive or not but do let me know what you think.

Also I wanted to mention the flexi possum, featuring a similar new link system - he is finally ready and will be available for subscribers either tomorrow or the following day.

As requested I have also finished the flexi Bulbasaur, with a flexi head, legs and each individual bulb section also being flexi - this little fidget I am going to release approximately around the same time as once I create a flexi Charmander and Squirtle so I can release all starter Pokémon at a similar time frame.

Today I wall also be starting a cute flexi dachshund as well as looking into completing some more requests and hope to bring as much joy and fun to all your 3D printers soon so what are you most looking forwards too?