Axolotl Flex (design 2) The second of my articulated axolotl designs. 1000% prints fine but i would recommend at least 110%. at 100% you may need to just gently release the legs. picture is 100% and 180% 0.2 layer, 10% infill prints without supports. ive printed using bambu super tack plates and adhesion wasn't an issue. but please be aware at 100% it is small so please ensure good adhesion. if you run into issues try adding a brim or using a touch of glue. I really would recommend the super tack or similar plate like BIQU cryo freeze etc I will be release this as a free model for personal use over on maker world. probably for a limited time.