2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
Simple-ish set of parts to make mounting a Rx and VTX a little easier on the back end of a Bangarang XL. Print it in PLA or PETG or even TPU. Slide fit over the rear standoffs, and clamps down with the top plate.
Licensed under Creative Commons, Attribution, Non Commercial, version 4. https://creativecommons.org/licenses/by-nc/4.0/legalcode.txt
Category:
1 Likes3 DownloadsOctober 14, 2021
1 Likes3 DownloadsOctober 14, 2021
This model is restricted by licensing terms.
View license.