Planned maintenance is currently underway. Some operations on Thangs might be interrupted.
Looking to gain more exposure and add an additional revenue stream?
Could you make it when it was on the side of the building
awesome design, thanks!!
HOW DO YOU DO THIS STUFF!? AMAZING!
snow
Thank's for sharing, great model
https://www.youtube.com/watch?v=dPPVDZfDIj0
check them out on youtube to see how they made the pitmonster
Which software did u use to create it?
Great model! My cr10 mini keeps knocking over the tail so i had to add 1 tiny custom support to the base of the tail to get it working. Came out beautiful tho for the Rancor Challenge!
Which software did you use to do this
printed with 2 walls and 15% infill. Had to use manual supports for the tail (hot glue :))
ITS PRINTING SO WELL! Cant wait till my Octolapse is done!
This thing is beautiful ❤️ ❤️ ❤️
got 2 of them. One on MP Mini Delta. Second on Powerspec Dual Ultra... 20% infill as well. came out niiice...
Went back and checked my print settings, actually did 20% infill
I printed 2 of these full scale on my idex printer. 10% infill, 4 walls, no supports. Both came out absolutely perfect.
I put some supports under the arm pits, tail and the chain. It came out great!
Recommended infill amount?
Nice Model ChaosCoreTech!
Discussions — Rancor (Pit Monster)
Could you make it when it was on the side of the building
awesome design, thanks!!
HOW DO YOU DO THIS STUFF!? AMAZING!
snow
Thank's for sharing, great model
https://www.youtube.com/watch?v=dPPVDZfDIj0
check them out on youtube to see how they made the pitmonster
Which software did u use to create it?
Which software did u use to create it?
Which software did u use to create it?
Which software did u use to create it?
Great model! My cr10 mini keeps knocking over the tail so i had to add 1 tiny custom support to the base of the tail to get it working. Came out beautiful tho for the Rancor Challenge!
Which software did you use to do this
printed with 2 walls and 15% infill. Had to use manual supports for the tail (hot glue :))
ITS PRINTING SO WELL! Cant wait till my Octolapse is done!
This thing is beautiful ❤️ ❤️ ❤️
got 2 of them. One on MP Mini Delta. Second on Powerspec Dual Ultra... 20% infill as well. came out niiice...
Went back and checked my print settings, actually did 20% infill
I printed 2 of these full scale on my idex printer. 10% infill, 4 walls, no supports. Both came out absolutely perfect.
I put some supports under the arm pits, tail and the chain. It came out great!
Recommended infill amount?
Nice Model ChaosCoreTech!