MORPH | Fast Print Stackable Egg Cup

I wanted an egg cup that was: • simple • stackable • printable in 5–10 minutes in vase mode

The MORPH egg cup delivers all of that, with a shape that gently transitions from a square to a circle.

DIMENSIONS | Ø55mm x H35mm

3D PRINT SETTINGS: The cup prints upright.

It is meant to print in vase mode with thick wall lines. The round hole has a diameter of 40mm, which is fine for standard eggs. But you can scale the model up or down if you want a bigger or smaller hole for your eggs.

For a 0.8mm nozzle: • activate "vase mode" (spiral vase or spiralize) • Layer height: 0.4 to 0.6mm/layer • Line width: 1.5mm • Bottom shell layers: 0

For a 0.4mm nozzle: • activate "vase mode" (spiral vase or spiralize) • Layer height: 0.2mm/layer • Line width: 1mm • Bottom shell layers: 0

Happy printing!