AJAX513 followers

Gridfinity HueForge TD Step Test Swatch Bins

452 downloads · 3 years ago · This is a collection of Gridfinity bins designed to not only store your filament TD_Step_Test swatch

Description

This is a collection of Gridfinity bins designed to not only store your filament TD_Step_Test swatches. These bins not only store your swatches, but the also snap into place to prevent accidental spillage.

Bins ending with 4TD are designed to store filaments with a TD of 4 or less. They allow for a single TD_Step_Test swatch to snap into place.
Bins ending with TD8 are designed to store filament with a TD between 4.2 and 8. They are designed with a double space to allow for storage of the TD_Step_Test swatch and a TD_Step_Test_Plus_4 swatch stacked together. These also snap into place.
Bins ending with TD12 are designed to store filament with a TD between 8.2 and 12. They are designed with a triple space to allow for storage of the TD_Step_Test swatch and two TD_Step_Test_Plus_4 swatches stacked together. These also snap into place. These bins were designed to pair perfectly with my Official HueForge TD Step Test found here https://than.gs/m/917384 and my Rugged Box Gridfinity Parametric model, found here https://than.gs/m/918184

Tags:

Discussions

meicalnissyen2 years ago

Greetings !

I am holding 1 of your products, and looking at your fluency with a format I use.

how do you feel about whipping up a gridfinity holder for your TD-1 ? perhaps a 2 square proffering the TD-1labeled corner at mebbe 20deg ?

d.basney902 years ago

Will these work with your rolling gridfinity boxes?

mmakam23 years ago

these don't fit the +4step test

AJAX3 years ago

Correct, the +4 will only fit in the 8TD & 12TD bins. The intention is, say you have a TD of 7, you stack the step test and the +4 together and slot them into place in the 8TD bin.