We launched our own site 42prints.com

We launched our own site — 42prints.com.

This is the thing we've been hinting at in studio updates for a few weeks. It's basically a home for the stuff that never fit neatly here: pre-sliced .3mf files for specific printers, the colorway charts we kept getting DM'd about, multi-part kits where the slicer setup matters more than the STL itself.

The story is honestly not that deep. We kept answering the same questions ("did you slice this for X1C", "what filament color is that", "where's the variant with the headphones") in DMs, on Discord, in Cults comments. At some point you realize the answer should just be a link.

So we built the link.

Thangs stays exactly what it was for us — single-STL drops, the behind-the-scenes posts, the designer feed where people can actually reach us. The new site is where the kit version lives. Both work; they're not competing.

If you're already subscribed to us here on Thangs — your subscription works on 42prints.com too. Same login won't carry over (different platforms), but reach out and we'll set you up on our side with full member access at no extra cost. No double-paying.

Questions, weird bugs, "where's my access" — write us at support@42prints.com

The plan from here: new models drop on 42prints.com a week or two before they show up anywhere else, and members there get the full kit — sliced profiles, colorways, variants — instead of just the raw mesh.

Anyway — 42prints.com. Drop in when you have a minute.

— 42 STUDIO