sadly outcome is even worse .. my print looks nothing like the gaps in the images of the designer. I will use a completely different filament, tweak settings and try again. My suspicion is that this issue is filament specific.
ok it’s definitely the filament … I have just printed a model where I know the tolerances are tight but still permit movement and this filament fused in that model too.
Next task is to verify that a different filament will work well.
I have just started to print one with Bambu matte PLA and already I can tell this will work .. there is a visible gap between the bases of the columns after 4 layers. I will report back after the print finishes, I am printing by object 4 different Bambu matte PLA filaments.
.jpg&w=3840&q=75)
sadly outcome is even worse .. my print looks nothing like the gaps in the images of the designer. I will use a completely different filament, tweak settings and try again. My suspicion is that this issue is filament specific.
ok it’s definitely the filament … I have just printed a model where I know the tolerances are tight but still permit movement and this filament fused in that model too.
Next task is to verify that a different filament will work well.
I have just started to print one with Bambu matte PLA and already I can tell this will work .. there is a visible gap between the bases of the columns after 4 layers. I will report back after the print finishes, I am printing by object 4 different Bambu matte PLA filaments.
Fully tested, failure definitely filament dependent.
I will post successful images separately.