tracking pixel
24kJames

1S Optimized Canopy 3inch Toothpick/Babytooth

by
24kJames
Follow
Follow
Remix Model
1S Optimized Canopy 3inch Toothpick/Babytooth 3d model
1S Optimized Canopy 3inch Toothpick/Babytooth 3d model
2D
3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4797922.

I haven't seen a better whoop mount, nano camera canopy. Cheers to DiAleksi for the excellent design. I just had to make a couple tweaks to turn it into the ultimate 1S 3inch/Babytooth canopy. It weighs less than a gram, prints in about 20 minutes, doesn't require supports, and when printed with nylon, or PCTPE, it;'s effectively indestructible.

After my tweaks, it easily mounts the Caddx Ant (and likely other nano size/14mm cameras,) and provides top deck USB port access for the two most common whoop AIO layouts. There's one for HappyModel, and JHEMCU port spacing which has the USB port further in board, and there is one to accommodate boards with the port further outboard (near the edge,) like the FPVCycle 1S 2 in 1 FC/ESC, the EMAX Nanohawk 4 in 1 AIO, and others.

Use this design only if you want the lightest, strongest, easiest and fastest printing canopy, with great 'quality of life,' features, and nice aesthetics, for mounting a Caddx Ant to your Babytooth, Whoop, or other 25.5mm mount spacing multirotor/aircraft.


0 Likes5 DownloadsDecember 3, 2021


0 Likes5 DownloadsDecember 3, 2021
This model is restricted by licensing terms.