Filament Vase – Upcycled Design

Short Description: A simple, support-free print that turns leftover filament ends into a structural, decorative vase. For filaments of 1.75mm Thickness

Full Description: This vase is designed to make use of those last few meters on a spool that usually go to waste. It uses the natural coil of the filament to create a bouncy, flexible structure held between two rings and a central column.

The top is sized to fit a large Starbucks cup, which makes it easy to hold water for small flowers and swap it out for cleaning. For longer stems, you can just place the whole assembly over a separate water container.

Highlights:

• Sustainable: Made specifically to upcycle filament offcuts.
• Modular: Sized for a standard large Starbucks cup or used as a sleeve for larger vases.
• Expandable: Includes a connector ring to stack units for extra height.
• Support-Free: No supports, no glue, and no post-processing required.

What’s Included:

• Central fluted column
• Large and small filament rings
• Vertical connector ring
• Filament size jig (to get the lengths right)
• Assembly guide