This bundle of wall shelfs is a highly naturalistic replica of real “Ganoderma Applanatum” that I found and 3d-scanned. Included are a composition and two individual shelves, all as single color and separated dual color files. No AMS required!

Instructions

• Print your parts
• Glue the bottom parts into the corresponding top. Please check the images for insertion directions.
• You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
• Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.
• Enjoy!

Print settings Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Infill: 15% Build plate adhesion type: none for all expect Ganoderma_applanatum_A_dual_02 should get a brim