Woven Ball
356 downloads · 3 years ago · This Woven Ball is impossible to print. Unless you use water soluble PVA filament for supports!
Se
This model is restricted by licensing terms.
View license.
This Woven Ball is impossible to print. Unless you use water soluble PVA filament for supports!
See here for video: https://youtu.be/o5lJ5TMQRpk
The top inside of the ball has overhangs that need to be supported or the print will fail. Typical supports can’t be use because the holes are too small to allow removal of supports from inside the ball. With PVA filament, you can use all the supports you need, soak the finished print in warm water, and watch the supports simply dissolve away!
This model printed with my Snapmaker J1 IDEX printer using Snapmaker PVA filament and Sunlu White PLA.
Woven Ball
356 downloads · 3 years ago in and
This model is restricted by licensing terms.
View license.
Aizawa Strange Attractor Sculpture
Bio Blob
Flame Lamp
Crystal Lamp
Tooth Fairy House
Crystal Citadels
Shack Pack - Sober
Shack Pack - Tipsy
Shack Pack - Plastered
Stellar Blooms
Cut Crystal Eggs - Set 2
Cut Crystal Eggs - Set 1
Holly Berry Clusters
Holly Berry Branches
Poinsettia
Spruce Branches
Fir Branches
Hens and Chicks - Resin
Moneywort
Your prints are sky high! I mean that as a compliment.
On the whole, what is your general opinion of Sunlu filaments?
Came out good at 50% with no soluble support!