Textured Snap Egg (Circle)
Textured snap-together eggs large enough to hold a few chocolates. Touch them up with a bit of colour?
See here for video: https://youtu.be/J8gPYT0c8-4
Download the full set: Download the full set: Diamond: https://than.gs/m/812746 Square: https://than.gs/m/812751 Circle: https://than.gs/m/812752
The best way to print these is as oriented, with the model raised off the build plate 3mm and tree supports underneath. You will likely need to smooth the surfaces. If they are too tight, snapping them together and apart a few times will loosen it up.
Other snap-together eggs: Egg Snaps: https://than.gs/m/810065 Basketball: https://thangs.com/mythangs/file/796742 Tennis Ball: https://thangs.com/mythangs/file/796748 Baseball: https://thangs.com/mythangs/file/796753
Textured Snap Egg (Circle)
Bouali Strange Attractor Sculpture
Aizawa Strange Attractor Sculpture
Bio Blob
Flame Lamp
Crystal Lamp
Tooth Fairy House
Crystal Citadels
Shack Pack - Sober
Shack Pack - Tipsy
Shack Pack - Plastered
Stellar Blooms
Cut Crystal Eggs - Set 2
Cut Crystal Eggs - Set 1
Holly Berry Clusters
Holly Berry Branches
Poinsettia
Spruce Branches
Fir Branches
Hens and Chicks - Resin
How do put support underneath the model? I put the model over the plate in cura with drop model to plate deactivated, but when slicing it put the first layer back on the plate. I will attempt to print with lay flat to plate option which give me three contact point on plate, activate brim and put some support under the arches. Thx