Introducing Decor N' Store! A new, fun, modular decor and storage system ALL IN ONE! Create customizable decor, that doubles as practical storage, or even turn it into a LED lamp! With multiple designs to choose from, the options are endless! The question is, how will YOU Decor N' Store?

Modular inserts make this easy to assemble and customize to your hearts content! Create one of the designs below or mix and match to make your decor n' store as unique as you!

INSTRUCTIONS

Its as easy as printing 3 pieces: Base, Insert and Lid! Just slide the male end of the insert into the female groove of the base piece for it to sit in place. Stack inserts and the lid the same way.

Note: there are 2 versions of each base (LED/NO_LED). No_LED if you just want to make the storage containers standalone. If you want to print the LED lamp version, please print the base with _led at the end of the name. Those files have the cutout for the power wire.

4 Designs Available: -Fluted -Knurled -Bubbles -Wavy (More designs can be added if there is interest!)

For LED lamp version: These LED's and controller are what I used in the video below, but feel free to use what you like:

-LED rings:

https://www.amazon.com/Integrated-Drivers-forArduino-Raspberry-ESP8266/dp/B08PCLYT7J?pd_rd_w=9UBVU&content-id=amzn1.sym.c82e8d5f-baa6-4f2a-894c-1a07d5f5bab0&pf_rd_p=c82e8d5f-baa6-4f2a-894c-1a07d5f5bab0&pf_rd_r=65A2G8P66S8XP753NZYH&pd_rd_wg=w9sCh&pd_rd_r=8c04e428-2c01-4770-bd8b-b8649e94b912&pd_rd_i=B08PCLYT7J&psc=1&ref_=pd_bap_d_grid_rp_0_1_t

-Controller:

https://magwled.com/products/dgrz-led-cpd-36-1-mini

PRINT SETTINGS For Base, Insert and Lid (Non-led version) :

Perimeters: 2-3 Layer height: 0.2-0.25mm Infill: 10-15% No supports needed! (print with male end of insert upward)

For divided storage insert:

Infill: 25-50% Perimeters: 3 0.2mm layer height (There are grooves on each end of the top surface that friction fit fairly easily into the insert pieces ONLY! Please do not use these with the bases or lids. If tolerance issues make it too loose/tight to fit into the insert, please adjust the scale of the part by 1% in either direction until fitting!. If problems still occur, please let me know and I can look into adjusting the tolerances. You should print this on a printer with good tolerances. )

For LED Lamp:

Base can be printed as above Suggested to print insert and lid with 0-5% infill Layer height: 0.2-0.25mm 3-4 perimeters 4-5 bottom layers (NOTE: recommend printing on a machine with decent/ good bridging since there is no infill printed. You can print LED diffusers with some infill, you''l just have infill peaking thru the light.)

Last note: Tolerances should be adequate for pieces to fit into one another fairly freely. If too tight, please adjust scale by +1%. If still having issues, please let me know and I can look into adjusting the tolerances.

Please refer to the video for more information! Happy printing!